| |
1. Cut
your two lenses to the outside size of the frame (rimless
edging) in order to get a perfect fit once the attachments
are fixed. |
|
(click
on the pictures to enlarge them).
GOOD BAD BAD
[too
small] [too large]
|
2. Fix
the lenses over the frame using the edging pads. Place the
bridge onto the lenses,with a felt pen mark the position of
the drills holes. Then mark the positions of the holes for
the other attachments (lower and temploral).
|
|
3. By using
the drilling template and the hand drilling machine (with its
supplied 1.3 mm. diameter drill bit) make your two holes per
lens (lower and temploral attachments ).
|
Use the
bridge as a template for the third drill.
|
4. Choose
the proper size of attachments depending upon the kind of
the frame or the thickness of the lens (rimless) you have
to clip-on. |
[Rimless
eyeglasses] [Rim
eyeglasses]
[Binding is on the rim (New)]
|
5. Introduce the attachment as far as it will go and if necessary
use a reamer.With the help of a pair of pliers, pull the end
until the two wide parts of the arrow has come through. Trim
leaving a 1 mm overlapping beyond the lens surface.
|
Before
threading the bridge align the holes of the lens and bridge
with a reamer. When pulling let only one pin of the arrow
come through; then trim to size.
|
