| |
1. Cut
your two lenses to the outside size
of the frame (rimless edging) in order to get
a perfect fit once the attachments are fixed: |
|
(click
on the pictures to enlarge them).
GOOD BAD BAD
[too
small] [too large]
|
2.
Superimpose your lenses on the front of the frame. With the
help of a felt pen mark the exact positions of the attachments
(nearest to the bridge and the temples) in order to avoid any
rotation of the lenses. |
GOOD BAD
[attachments : correct position] [attachments : too far]
[lenses can’t
turn] [lenses can turn]
|
3.
By using the drilling template and the hand drilling machine
(with its supplied 1.3mm diameter drill bit) make three holes
per lens. 
|
If you don’t use the drilling template, remember to drill
at 2.5mm to the edge of the lens. 
|
4. Choose
the proper size of attachments depending upon the kind of
the frame or the thickness of the lens (rimless) you have
to clip-on. |
[Rimless
eyeglasses] [Rim
eyeglasses]
[Binding is on the rim (New)]
|
5. Introduce the attachment as far as it will go and if necessary
use a reamer. With the help of a pair of pliers, pull the end
until the two wide parts of the arrow has come through. Trim
leaving a 1mm overlapping beyond the lens surface. |
|
